Table of Contents
Advertisement
TouchCenter (cont'd)
Configuring a TouchCenter
To configure a new TouchCenter do the following:
1 - Set an Address
On first power up, the TouchCenter will immediately prompt for a bus address. This should be any valid
address that is not shared with any other keypad on the same RS485 (AB) Line. The default address is
usually acceptable.
If the address has previously been set and the address prompt does not appear, re-power the keypad and
within five seconds of power up, press the Console mode button
address.
2 - Register with the Control Panel
Once the address has been selected, the control panel must be repowered or, if another keypad is already
configured, exit from Engineer mode and the new TouchCenter will be registered.
The Home Page will be displayed and the keypad is ready to use.
NOTE: Refer to the control panel literature for valid addresses. One TouchCenter can be fitted to each
Galaxy RS485 line.
Set-up Menu
The TouchCenter has a number of configuration settings which are set up directly within the keypad. To
access these settings, the TouchCenter must be in communication with the Galaxy Panel. The panel must be in
Engineer's mode. Proceed as follows:
1.
From the home screen press the SECURITY button and then enter the Authorisation code. This is the
Engineer PIN of the control panel. The Security screen is displayed.
2.
Press the MORE CHOICES button to enter the More Choices screen.
3.
Press the KEYPAD SETUP button to enter the Setup screen.
4.
Press the KEYPAD TEST button.
From this screen, the following options are available;
Self Diagnostics
A series of diagnostic tests are provided that allows verification of correct operation of the TouchCenter and
its connection to the Galaxy system. There are three diagnostic tests:
•
LCD Display Test
•
Audio Test
•
LED Test
Address
This allows the RS485 address to be changed. A change to this will require reconfiguration of the
TouchCenter with the control panel.
Galaxy Dimension Installer Manual
Or
then press the ent button to change the
4-10
- Quick Links:
- Pcb Layout
Hide quick links:
Advertisement
Table of Contents
