Advertisement
Tumble dryer supervisor level
Remote
Remote Update
SmartGrid
122
The machines are in a network and are connected to the Internet. All
machines are configured as slaves. Data is synchronized over the
Internet.
External program selection is possible via an external terminal (pro-
gram may only be started on the machine). However, programs may
also be selected and started on the machine.
Factory default: on
The RemoteUpdate function is used for updating the software in your
dryer.
RemoteUpdate is activated by default.
If you do not install a RemoteUpdate, you can continue to use your
tumble dryer in the usual way. However, Miele recommends installing
RemoteUpdates.
Miele's RemoteUpdate function can only be used if the dryer is con-
nected to a WiFi/LAN network and you have an account in the Miele
Professional app. The dryer must be registered in the app.
See the Miele Professional app for terms of use.
If a RemoteUpdate is available for your tumble dryer, it will be dis-
played automatically when the supervisor level is open.
You can choose to start the RemoteUpdate immediately or wait until
later. If you select "Start later", the prompt to run the RemoteUpdate
will be displayed again the next time you switch on your tumble dryer.
The RemoteUpdate can take a few minutes.
Please note the following information about the RemoteUpdate func-
tion:
- You will only receive a message when a RemoteUpdate is available.
- Once a RemoteUpdate has been installed, it cannot be undone.
- Do not switch off the tumble dryer during a RemoteUpdate. Other-
wise, the RemoteUpdate will be aborted and will not be installed.
The
setting is only visible if a WiFi network has been set up
SmartGrid
and activated. This function can be used for starting your Miele Pro-
fessional Machine automatically at a time when your energy costs
are most economical.
Activating
SmartGrid
the
sensor control to set SmartStart. The tumble dryer will then
Timer
start within the timeframe specified when it receives a signal from the
energy supplier. If it has not received a signal from the energy supplier
by the latest start time set, the tumble dryer will start automatically.
Factory default: Off
gives the
sensor control a new function. Use
Timer
Advertisement
