Advertisement
Res. moisture dis-
play
Visibility parame-
ters
Display off status
Machine off status In order to save energy, the tumble dryer will switch off automatically
Delay start
In addition to displaying the drying level, the residual moisture can
also be indicated as a percentage.
- Factory default:
Without % value
-
With % value
Various parameters are offered/displayed when a program is se-
lected. You can decide which parameters should not be displayed.
These parameters can then not be edited during program selection.
-
Residual moisture
-
Duration
-
Low temperature
-
Anti-crease
-
Load size
-
Drying temperature
The display switches off to save energy; only the Start/Stop sensor
control flashes slowly. You can change this setting.
Changing this setting leads to increased energy consumption.
-
Off
No switching off
-
On (10 min.) Not curr.prog.
The display will remain on while the program is running but will go
out 10 minutes after the end of the program.
-
Logo (10 min.) Not curr.prog.
The display will remain on while the program is running but the logo
will light up 10 minutes after the end of the program.
- Factory default:
On after 10 min.
The display is switched off after 10 minutes.
-
On (30 min.) Not curr.prog.
The display will remain on while the program is running but will go
out 30 minutes after the end of the program.
-
Logo (30 min.) Not curr.prog.
The display will remain on while the program is running but the logo
will light up 30 minutes after the end of the program.
-
On after 30 min.
The display will go out after 30 minutes.
after the end of the program or if no further selection is made. You
can change this setting.
Changing this setting leads to increased energy consumption.
- No switch off
- Factory default: Switch off after 15 minutes
- Switch off after 20 minutes
- Switch off after 30 minutes
The delay start (timer) can be activated or deactivated.
Tumble dryer supervisor level
113
Advertisement
