Advertisement
Problem
F196
The message
"Hydro-
appears
Clean" continued
after switching on.
The display shows a
message not listed in
this table.
Possible cause and remedy
There is a fault.
Switch the steam combination oven off and back on
again.
The floor filter is not fitted correctly.
Switch the steam combination oven off.
Fit the floor filter.
Switch the steam combination oven back on again.
If the fault message appears again, contact Miele.
The cleaning process was interrupted by a power
failure or by the appliance being switched off.
After switching the steam combination oven back on
again, the rinsing and drying phases are carried out
automatically to remove any potential cleaning agent
residues. This process takes approx. 1:30 hours. If
there is an interruption during the drying phase, the
process takes approx. 30 minutes.
Normal operation of the steam combination oven is
only possible again upon completion.
Follow the instructions in the display.
Please note that the cleaning result will not be
optimal.
There is an electronic unit fault.
Interrupt the power supply to the steam
combination oven for approx. 1 minute.
If the problem persists after power is restored,
please contact Miele.
Problem solving guide
141
Advertisement
